3″ Conduit Elbow Long Radius

3″ Conduit Elbow Long Radius

LONG RADIUS ELBOW

ELBOW LONG RADIUS 3″ RIDGID CONDUIT

FINISHING: HOT DIP GALVANIZED

Rigid Metal Conduit (RMC) – Steel Elbows

Rigid Metal Conduit (RMC) Steel Elbows Conforms With:

  • ANSI – American National Standard for Electrical Rigid Steel Conduit (ERSC) ANSI, C80.1
  • UL Standard for Electrical Rigid Metal Conduit – Steel, UL 6
  • National Electrical Code 2008 Article 344
  • Federal Inspection WW-C-581 (Class 1 Type A)
  • ANSI/ASME B.1.20.1-1983, Standard for Pipe Threads, General Purpose (Inch)
  • Rigid Metal Conduit Elbows are Hot-Dip Glvanized

Rigid Metal Conduit (RMC) Steel Elbows:

  • Permitted under all atmospheric conditions and occupancies
  • Shall be permitted to be installed in concrete, in direct contact with the earth
  • Permitted in areas of severe corrosive influences where protected by corrosion protection and judged suitable for the condition
  • Permitted in or under cinder fill where subject to permanent moisture when protected on all sides by a layer of noncinder concrete no less than 2 in. (50 mm) thick or with corrosion protection judged suitable for the condition
  • May be used with Aluminum fitting and enclosures

SURABAYA TEKNIK

Website:

Leave a Reply

Your email address will not be published. Required fields are marked *